Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CAUTION!
1.
For power-saving's sake, it is strongly recommended to enable AMD's Cool 'n'
Quiet
TM
technology under Windows system. See APPENDIX on page 52 of
"User Manual" in the Support CD to enable AMD's Cool 'n' Quiet
2.
This motherboard supports Untied Overclocking Technology. Please read "Un-
tied Overclocking Technology" on page 29 for details.
3.
Although this motherboard offers stepless control, it is not recommended to
perform over-clocking. Frequencies other than the recommended CPU bus
frequencies may cause the instability of the system or damage the CPU.
4.
While CPU overheat is detected, the system will automatically shutdown.
Before you resume the system, please check if the CPU fan on the motherboard
functions properly and unplug the power cord, then plug it back again. To
improve heat dissipation, remember to spray thermal grease between the
CPU and the heatsink when you install the PC system.
5.
This motherboard supports NVIDIA SLI
Graphics Feature" on page 13 for jumper settings. PCIE3 slot is intended
TM
for SLI
function. If you plan to install only one PCI Express VGA card to
this motherboard, please install it to PCIE1 slot. For the information of the
compatible SLI
TM
Mode PCI Express VGA cards, please refer to the "Sup-
ported PCI Express VGA Card List for SLI
proper installation of PCI Express VGA card, please refer to the installation
guide on page 11.
6.
Before installing SATAII hard disk to SATAII connector, please read the
"SATAII Hard Disk Setup Guide" on page 25 to adjust your SATAII hard disk
drive to SATAII mode. Besides, you are allowed to downgrade the SATAII
hard disk to SATA hard disk (from SATAII 3Gb/s down to SATA 1.5Gb/s),
and connect it to the SATAII connector. You can also connect SATA hard
disk to SATAII connector directly.
7.
This motherboard supports eSATAII interface, the external SATAII
specification. Please read "eSATAII Interface Introduction" on page 22 for
details about eSATAII and eSATAII installation procedures. (Port Multiplier
Technology is not supported with eSATAII interface on this motherboard.)
8.
Power Management for USB 2.0 works fine under Microsoft
SP1 or SP2 / 2000 SP4.
ASRock K8SLI-eSATA2 Motherboard
TM
technology.
TM
technology, please read "Dual
TM
Mode" on page 8. For the
®
Windows
®
XP
7 7 7 7 7
Werbung
Inhaltsverzeichnis
