Installing An Expansion Card - ASROCK ALiveNF4G-DVI Bedienungsanleitung

All manuals and user guides at all-guides.com
2.3 2.3 2.3 2.3 2.3 Expansion Slots (PCI Express Slots and PCI Slots) Expansion Slots (PCI Express Slots and PCI Slots) Expansion Slots (PCI Express Slots and PCI Slots) Expansion Slots (PCI Express Slots and PCI Slots) Expansion Slots (PCI Express Slots and PCI Slots)
There are 2 PCI Express slots and 2 PCI slots on ALiveNF4G-DVI motherboard.
PCIE Slots: PCIE1 (PCIE x16 slot) is used for PCI Express cards with x16 lane
width graphics cards.
PCIE2 (PCIE x1 slot) is used for PCI Express cards with x1 lane
width graphics cards, such as Gigabit LAN card, SATA2 card, etc.
PCI Slots: PCI slots are used to install expansion cards that have the 32-bit PCI
interface.

Installing an expansion card

Installing an expansion card Installing an expansion card
Installing an expansion card Installing an expansion card
Step 1. Before installing the expansion card, please make sure that the power
supply is switched off or the power cord is unplugged. Please read the
documentation of the expansion card and make necessary hardware
settings for the card before you start the installation.
Step 2. Remove the system unit cover (if your motherboard is already installed in
a chassis).
Step 3. Remove the bracket facing the slot that you intend to use. Keep the
screws for later use.
Step 4. Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
Step 5. Fasten the card to the chassis with screws.
Step 6. Replace the system cover.
2.4 Dual Monitor and Surround Display Features 2.4 Dual Monitor and Surround Display Features
2.4 Dual Monitor and Surround Display Features 2.4 Dual Monitor and Surround Display Features 2.4 Dual Monitor and Surround Display Features
Dual Monitor Feature
This motherboard supports dual monitor feature. With the internal dual VGA output
support (DVI-D and D-Sub), you can easily enjoy the benefits of dual monitor
feature without installing any add-on VGA card to this motherboard. This
motherboard also provides independent display controllers for DVI-D and D-Sub to
support dual VGA output so that DVI-D and D-sub can drive same or different
display contents. To enable dual monitor feature, please follow the below steps:
1. Connect the DVI-D input monitor cable to the VGA/DVI-D port on the I/O panel of
this motherboard. Connect the D-Sub input monitor cable to the VGA/D-Sub port
on the I/O panel of this motherboard.
2. If you have installed onboard VGA driver from our support CD to your system
already, you can freely enjoy the benefits of dual monitor function provided by
VGA/DVI-D and VGA/D-Sub ports with this motherboard after your system
boots. If you haven't installed onboard VGA driver yet, please install onboard
1 2 1 2 1 2
1 2 1 2
ASRock ALiveNF4G-DVI Motherboard