Getting Started; Cutting Mode - GYS 40FV Bedienungsanleitung

MADE IN FRANCE
2 - INSTALLATION OF THE TORCH CONSUMABLES :
Before changing the consumables, cut the power supply using the interrupor behind the machine.
To use the torch, a complete set of consumables must be installed in the correct order: electrode, diffuser, tip and nozzle.

GETTING STARTED

(SEE TABLE AND GRAPH ON PAGE 3)
• Connect the regulator, and the pneumatic tip for the mahine.
• Connect the unit to the electricity and air supply.
• Turn on the power switch at the back of the machine.
• Connect the earth clamp to a clear area of the workpiece.
• Adjust the pressure
• Choose the sheet metal
• Adjust the cutting current with the adjustment buttons (2).
• Start cutting.

CUTTING MODE

(SEE THE GRAPHICAL INTERFACE PAGE 3)
Sheet metal mode :
• Choose this mode if cutting metal that is not perforated.
• Cutting can be stopped in 2 ways
- By releasing the trigger.
- When the arc no longer meets the metal workpiece.
Metal Mesh mode
:
• Choose this mode when cutting perforated metal. This mode ensures a continuous arc, even if passed over holes.
• Stop cutting by releasing the trigger, or will stop automatically after 3 seconds without encountering metal.
During either the cutting phase, or torch cooling phase, if the air pressure goes above/below the recommended range the warning LED (5) flashes.
This is to warn the user that the air pressure is outside of optimum level.
SETTING UP THE PRESSURE
Air Pressure Measurement mode (integrated pressure gauge)
• When this mode is selected, the display shows the current air pressure, bar or PSI.
• Press and hold the change mode button (8) to select the unit of measurement.
• To start measuring, briefly press the trigger, the air comes out of the torch and the pressure is displayed followed by a letter «b» for bar or «p» for
PSI.
• Use the adjustment knob on the air regulator to reach the desired value.
- If the pressure is too low or too high the display will flash.
- If the pressure is too low «no air» appears.
• To exit the air measurement mode, briefly press the trigger or the change mode button (8)
• Set the current depending on the type and thickness of cutting metal. (graph page 3)
SAFETY TRIGGER
The torch is equipped with a safety latch to prevent accidental use: Unlock it and pull the trigger as below:
1
Wear appropriate protective equipment. Stay away from the tip of the torch. Keep your hands away from the cutting trajectory. Never
point the torch towards you or another person.
PLASMA CUTTER 40 FV
Nozzle Tip
or metal mesh mode with the mode adjustment button (8).
(SEE TABLE AND GRAPH PAGE 3)
Diffuser Electrode
:
2
Torch
3
EN
17