Herunterladen Diese Seite drucken

Ferm LMM1006 Gebrauchsanweisung Seite 6

Werbung

GB
Personnel
Never allow the device to be operated by children, or persons that are not familiar with the
D
device. Local regulations may prescribe a minimum age for using the device.
The operator or user is responsible for accidents or situations that are dangerous to other
persons or property.
NL
Preparation
Never operate the machine when other people, especially children, or household pets are
F
in the immediate operating vicinity of the machine.
The operator or user is responsible for accidents, injury, or damage to the property of other
persons.
E
Hearing protection and protective goggles must be worn when operating the machine.
Perform a visual inspection of the blades and screws for signs of wear and damage before
each use. Worn or damaged blades or screws must always be replaced as a complete set,
P
to avoid unbalanced vibration.
Protective goggles with side protection must always be worn when using devices with rear
ejection and uncovered rear rollers without a catching container
I
Do not use the device in bare feet or with open sandals
Always keep a careful eye on the ground when using the device, and remove all stones,
sticks, wires, bones and other foreign objects.
S
Before use, always check that the blades, blade bolts and cutting unit are not worn or
damaged. Worn or damaged blades and bolts must always be replaced as a complete set
to avoid unbalanced vibration.
FIN
Be very careful when using devices with multiple blades, since the rotation of one blade
can set the other blades in motion.
N
Operation
Only mow in daylight or good artificial light.
DK
If at all possible, do not operate the machine on wet grass, or take extra measures to
prevent slipping.
On sloping ground, always mow across the slope and never up and down the slope.
Exercise extreme care when changing direction on sloping ground.
Do not use the device on very steep slopes.
The blades must be stopped before the machine is tilted for transport. The blades must not
be operation when crossing surfaces that are not planted with grass, and also during
transport to and from the working area.
Do not change the regulator setting of the motor and do not over-rev the motor.
All blade and driving clutches must be disengaged before starting the motor.
Start and stop the motor in accordance with the operating instructions. The feet must be
kept a suitable distance away from the blades.
Never start the motor when standing in front of the grass ejection opening.
Do not place hands or feet near to or underneath rotating parts. Always keep away from the
ejection opening.
If at all possible, do not use the device on wet grass.
Ensure good traction when working on sloping ground.
Always walk and never run with the device.
Exercise extreme care when changing direction on sloping ground.
Exercise extreme care when turning or pulling the device towards you.
06
3. MONTERING
Montering af plæneklipperen
Se Fig. 1
Tilpasning af skærehøjde
Skub armen til den ønskede position for at sænke eller hæve klippehøjden.
Advarsel! Kun når der er slukket for motoren og skærebladet står stille!
Ledningsholder
Fig. 2
Sæt forlængerledningens stik i maskinens afbryder/stikkontaktforbindelse og fastgør med
ledningsholderen. Løkken i ledningen skal være så lang, så ledningen kan glide fra den ene
side til den anden i ledningsholderen.
4. BETJENING
Tænd/sluk-knap
Fig. 3
Advarsel! Start ikke maskinen i meget højt græs.
Tryk på sikkerhedsknappen på afbryder/stikkontakten og pres derefter løftestangen mod
maskinens håndtag. Hold løftestangen mod håndtaget og udløs sikkerhedsknappen. For at
stoppe maskinen, frakobles løftestangen. Løftestangen vil automatisk gå tilbage til en neutral
position.
Tips til græsslåning
Vær sikker på, at det område der skal slås er fri for sten, affald, ledninger og andre
forhindringer.
Forvis dig om, at alle fastskruninger (skruer, møtrikker, osv.) er fastspændt.
Jævnligt kontroller, at græopsamleren ikke er slidt.
Vælg skærehøjde i forhold til din plænes tilstand og højden på græsset.
For det bedste resultat bør højt græs slås af flere omgange. Anbefalet højde på det græs,
der skæres per gang, er maksimum 4 cm.
Det giver det bedste resultat, hvis græsset slås, når det er tørt.
Vær sikker på, at skærebladet kan dreje med den hurtigste fart; maskinen er så ikke
overlæsset.
For at beskytte ledningen, vær sikker på at den ligger på jorden bag dig, mens du slåer (Fig. 6).
Begynd græsslåningen ved at skubbe maskinen langsomt fremad. Hvis skærebladet
bliver langsomt eller motoren stopper, så er der ikke valgt en korrekt skærehøjde, eller du
skubber plæneklipperen for hurtigt.
Ferm
Ferm
GB
D
NL
F
E
P
I
S
FIN
N
DK
83

Werbung

Kapitel

loading

Diese Anleitung auch für:

Fgm-1800