Utilisation; Installation; Connecting The Battery Charger; Disconnecting The Battery Charger - NORAUTO PREMIUM HF1500 Gebrauchsanweisung

UTILISATION

A. Installation
IMPORTANT SPECIFICATION NOTE: This power system is to be used ONLY on
vehicles with 12V DC battery system. Do NOT connect to a 6V DC or 24V DC
battery system.
Never alter the AC cord or plug. If it will not fit, have a proper outlet installed by a
qualified electrician. Improper connection may result in an electric shock. If the supply
cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Before charging, confirm that the voltage of the battery is 12V by referring to the label
on the battery or from the information available relating to its application e.g. car user
manual.
When using this charger in proximity to the vehicle's battery and engine, stand the
charger on a flat, stable surface and be sure to keep all clamps, cords, clothing and
body parts away from moving parts of the vehicle. Keep enough space around the
appliance for allowing adequate ventilation.
ATTENTION: The battery terminal not connected to the chassis has to be connected
first. The other connection is to be made to the chassis, remote from the battery and
fuel line. The battery charger is then to be connected to the supply mains.
After charging, disconnect the battery charger from the supply mains. Then remove the
chassis connection and then the battery connection.
Incorrect connection, battery short circuit, location of battery and location of the battery
charger may create a hazard. Make sure that adequate preparation has been made
before proceeding.
B. Connecting the battery charger
If necessary, remove the battery from the vehicle, by following battery manufacturer
instruction manual.
Check the polarity of the battery posts. A positive (POS, P, +) battery post usually has a
larger diameter than the negative (NEG, N, –) battery post.
Follow the manufacturer's instructions to remove any insulating covers from the battery
posts.
Connect the positive (red) clamp from the battery
charger to the positive (POS, P, +) post of the
battery .
1
Connect the negative (black) clamp from the
battery charger to the negative (NEG, N, –) post
of the battery
Then, connect the AC plug of the battery charger
into the AC mains socket
If the Fault Icon
charger from main power, and connect clamps
by respecting the polarity.
C. Disconnecting the battery charger
Always disconnect the battery charger by following
below instructions:
- Unplug the battery charger from the main socket.
- Disconnect the black clamp.
- Disconnect the red clamp.
- If necessary, put back battery terminal protections.
.
2
3 .
lights up, unplug the
143