Electrolux IK1910SZR Benutzerinformation Seite 16

16 www.electrolux.com
Problem
Water flows on the floor.
Temperature cannot be set. The ActionFreeze or
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
The temperature in the wine
cellar is too high.
Possible cause
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Shopping Function func-
tion is switched on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The ActionFreeze function
is switched on.
The Shopping Function
function is switched on.
There is no cold air circu-
lation in the appliance.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
Many bottles are stored at
the same time.
There is no cold air circu-
lation in the appliance.
Solution
Attach the melting water out-
let to the evaporative tray.
Switch off ActionFreeze or
Shopping Function manually,
or wait until the function re-
sets automatically to set the
temperature. Refer to "Ac-
tionFreeze or Shopping Func-
tion function".
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Refer to "ActionFreeze func-
tion".
Refer to "Shopping Function
function".
Make sure that there is cold
air circulation in the appli-
ance.
Set a lower temperature.
Refer to "Closing the door".
Store less bottles at the same
time.
"Make sure that there is cold
air circulation in the appli-
ance.