Kenwood KDC-BT500U Bedienungsanleitung Seite 20

TROUBLESHOOTING
Symptom Remedy
"NA FILE" Make sure the disc contains supported audio files. ( 19, 20)
"NO DISC" Insert a playable disc into the loading slot.
"TOC ERROR" Make sure the disc is clean and inserted properly.
"PLEASE EJECT" Reset the unit. If this does not solve the problem, consult your
nearest service center.
"READ ERROR" Copy the files and folders onto the USB device again. If this does
not solve the problem, reset the USB device or use another USB
device.
"NO DEVICE" Connect a USB device, and change the source to USB again.
"COPY PRO" A copy-protected file is played.
"NA DEVICE" Connect a supported USB device, and check the connections.
"NO MUSIC" Connect a USB device that contains playable audio files.
"iPod ERROR" • Reconnect the iPod.
• Reset the iPod.
• Sound cannot be heard • Reconnect the Android device.
during playback. • If in [HAND MODE], launch any media player application on the
• Sound output only from
the Android device. • If in [HAND MODE], relaunch the current media player
• Restart the Android device.
• If this does not solve the problem, the connected Android device
Cannot playback at • Make sure KENWOOD MUSIC PLAY APP is installed on the
[BROWSE MODE].
• Reconnect the Android device and select the appropriate control
• If this does not solve the problem, the connected Android device
18
Android device and start playback.
application or use another media player application.
is unable to route the audio signal to unit. ( 20)
Android device. ( 7)
mode.
does not support [BROWSE MODE]. ( 20)
Symptom Remedy
"NO DEVICE" or • Switch off the developer options on the Android
"READING" keeps device.
flashing. • Reconnect the Android device.
• If this does not solve the problem, the
connected Android device does not support
[BROWSE MODE]. ( 20)
Playback is intermittent Turn off the power saving mode on the Android
or sound skips. device.
"ANDROID ERROR" / • Reconnect the Android device.
"NA DEVICE" • Restart the Android device.
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. ( 3)
Bluetooth pairing • Make sure you have entered the same PIN code
cannot be made. to both the unit and Bluetooth device.
• Delete pairing information from both the unit
and the Bluetooth device, then perform pairing
again. ( 9)
Echo or noise is heard • Adjust the microphone unit's position. ( 9)
during a phone • Check the [ECHO CANCEL] setting. ( 11)
conversation.
Phone sound quality • Reduce the distance between the unit and the
is poor. Bluetooth device.
• Move the car to a place where you can get a
better signal reception.
Voice calling method is • Use voice calling method in a more quiet
not successful. environment.
• Reduce the distance from the microphone when
you speak the name.
• Make sure the same voice as the registered
voice tag is used.