Alpine INE-W990BT Kurzanleitung Seite 16

4
Remove the mounting sleeve from the
main unit.
This unit
Slide the unit into the mounting sleeve and
secure it.
Mounting Sleeve
(Included)
Bracket
Pressure
1
Plates*
*1 If the installed mounting sleeve is loose in the
dashboard, the pressure plates may be bent slightly to
remedy the problem.
*2 The supplied face plate may be mounted.
14
-EN
Bracket keys
(Included)
Dashboard
Rubber Cap
(Included)
This unit
Hex Bolt
(Included)
Face Plate*
(Included)
5
When your vehicle has the Bracket, mount
the long hex bolt onto the rear panel of the
INE-W990BT and put the Rubber Cap on
the hex bolt. If your vehicle does not have
the Mounting Support, reinforce the head
unit with the metal mounting strap (not
supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*1)
already attached to the vehicle's chassis.
Connect all the leads of the INE-W990BT
according to details described in the
Connections section.
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
2
•
For the screw marked "*2, " use an appropriate screw for
the chosen mounting location.
6
Slide the INE-W990BT into the dashboard
until it clicks. This ensures that the unit is
properly locked and will not accidentally
come out from the dashboard.
Screw
*
2
Bolt Stud
*
1
This unit
Chassis