Closing The Door; Replacing The Lamp; Installation - Electrolux ERG1401AOW Benutzerinformation

Problem
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

9. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
The FastFreeze or Inten‐
sive Cooling function is
switched on.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The Intensive Cooling
function is switched on.
There is no cold air circula‐
tion in the appliance.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
9.1 Location
Solution
Switch off FastFreeze or
Intensive Cooling manual‐
ly, or wait until the function
resets automatically to set
the temperature. Refer to
"FastFreeze or Intensive
Cooling function".
Set a higher/lower temper‐
ature.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Refer to "Intensive Cooling
function".
Make sure that there is
cold air circulation in the
appliance.
to "Installation".
door gaskets. Contact the Authorised
Service Centre.
Refer to the assembly
instructions for the
installation.
ENGLISH 25