Features; Installation; Overhead Rigging - EuroLite LED SCY-6 RGB DMX Bedienungsanleitung

Features:

Classic RGB beam effect with LED technology!
1 row of lenses with 6 glass lenses • Via DMX, each color can be controlled at every lens • DMX-512 control
via regular DMX-controller (occupies 9 channels) • Sound controlled via built-in microphone • Microphone-
sensitivity adjustable via rotary-control • Strobe effect • Auto mode • Speed in Auto Mode adjustable via DMX
• Internal programs • Master/Slave function • Rugged compact housing in an appealing design • Ready for
connection with power cord and safety plug • Mounting bracket for installation on a trussing system included
• Particularly bright illuminating power of the 5mm LEDs • Advantages of LED-technology: extremely long life
of the LEDs, low power consumption, minimal heat emission, defacto maintenance free with brilliant light
radiation

INSTALLATION

Overhead rigging

Please consider the EN 60598-2-17and the respective national standards during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and or
damage to property.
The device has to be installed out of the reach of people.
If the device shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The device must never be fixed swinging freely in the room.
Caution: Devices in hanging installations may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do NOT install the device!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
DANGER TO LIFE!
16/22 00046978.DOC, Version 1.0