Werbung
Channel 2 – Speed
Value:
000 - 255
Channel 3 – Strobe
Value:
000 – 004
005 - 254
255 - 255
Channel 4 – Rotation
Value:
000 – 004
005 – 127
128 – 133
134 – 255
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Function:
Increasing speed of the Chaser-settings
under channel 1 (080 - 199)
Function:
Off
Flash, with increasing speed
Sound controlled flash
Function:
No rotation
Clockwise rotation, with increasing speed
Stop
Counter-clockwise rotation, with increasing
speed
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
19/20
00046984.DOC, Version 1.1
Werbung
Kapitel
