Herunterladen Diese Seite drucken

Master/Slave-Operation; Connection With The Mains; Operation; Stand Alone-Mode - EuroLite LED FE-600 RGB DMX Flower Effect Bedienungsanleitung

Werbung

Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Master/Slave-Operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LED SCY-6 RGB DMX you can find an XLR-jack and an XLR-plug, which can be
used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a stereo shielded cable. Connect
the OUT-jack with the IN-plug of the next device.

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the spot to the mains, the EUROLITE LED FE-600 RGB DMX starts running.
The LCD display lights up and you can choose the desired mode via the MODE button:

- STAND ALONE-MODE

Sound Control

Automatic
- MASTER/SLAVE MODE
- DMX MODE
STAND ALONE-MODE
Sound Control
To choose Sound Control Mode, press the MODE button then press the ENTER button to confirm.
International
L
N
17/20
resistor
00046984.DOC, Version 1.1

Werbung

loading