Electrical Connections; Installing The Appliance - Panasonic KY-B926SL Bedienungs- Und Installationsanleitung

Electrical Work

Electrical Connections

1. Turn off power.
Turn off power at the circuit breaker or remove fuses to the appliance branch circuit.
2. Connect the power cord.
Connect the power cord in accordance with all governing codes and ordinances.
■ Single-phase connection (220-240 V ~ 50 Hz)
Connect the wires in accordance with the instructions given in the following
table and diagram:
Electrical cable
KY-B926SL / KY-B925GL
N
L
KY-B915AL / KY-B915AB
N
L
■ Three-phase connection (380-415 V 3N~ 50 Hz / 380-415 V 2N~ 50 Hz)
Separate the L wires and connect them in accordance with the instructions
given in the following table and diagram:
Electrical cable
KY-B926SL / KY-B925GL
N
L1
L2
L3
KY-B915AL / KY-B915AB
N
L1
L2
50
EN-
All manuals and user guides at all-guides.com
Wire connection
: Yellow / Green
(Connect to the earth terminal)
N: Black, Cord No. 2 / 4 / 6
L: Black, Cord No. 1 / 3 / 5
(Connect to the live terminal)
: Yellow / Green
(Connect to the earth terminal)
N: Grey and Blue together
L: Black and Brown together
(Connect to the live terminal)
Wire connection
: Yellow / Green
(Connect to the earth terminal)
N: Black, Cord No. 2 / 4 / 6
L1: Black, Cord No. 1
L2: Black, Cord No. 3
L3: Black, Cord No. 5
(Connect to the live terminal)
: Yellow / Green
(Connect to the earth terminal)
N: Grey and Blue together
L1: Black
L2: Brown
(Connect to the live terminal)

Installing the Appliance

WARNING
Do not disassemble the top plate. Connected wire may become loose
and cause a malfunction.
1. Fasten the clamps to the appliance. (2 places at
rear)
■ Place the appliance on the packaging upper
filler when fitting clamps to prevent damage to
the countertop.
■ Match the clamp grips with the holes on the
sides of the appliance, then slide the clamp
from the right to the left to fasten them to the
appliance.
Upper filler
2. Embed the appliance in the countertop cutout
while keeping it is as level as possible.
■ Do not drop the appliance on the countertop.
■ Press down on top of the appliance to make
Correct
sure that it rests on the countertop.
■ Make sure that the spaces between the
countertop and the under surface of the
appliance are even in the front, rear, left and
right.
Incorrect
3. Connect the power cord.
■ See page 50.
CAUTION
If the cabinet does not have an opening in the front, the wiring needs
to be connected before the appliance is embedded into the countertop.
51
EN-