Hama BTH Run Bedienungsanleitung Seite 5

Note
The functions described in this section are only available for
Bluetooth-capable terminal devices.
5.1. Bluetooth pairing
Note – Pairing
• Make sure that your Bluetooth-capable terminal device is on
and Bluetooth is activated.
• Make sure that your Bluetooth-capable terminal device is
visible for other Bluetooth devices.
• For more information, please refer to the operating
instructions of your terminal device.
• The headset and the terminal device should not be any further
than 1 metre away from each other. The smaller the distance,
the better.
• Switch the headset on using the MF button (5).
• Press and hold the MF button (5) until the red and blue LEDs
flash alternatingly. The headset is searching for a Bluetooth
connection.
• Open the Bluetooth settings on your terminal device and wait
until Hama BTH RUN or Hama BTH ACTIVE appears in the list of
Bluetooth devices found.
• Select Hama BTH RUN or Hama BTH ACTIVE and wait until the
headset is listed as connected in the Bluetooth settings on your
terminal device.
Note – Bluetooth password
Some terminal devices require a password in order to connect
to another Bluetooth device.
• If your terminal device requests a password for connection
with the headset, enter 0000.
Note
• Once the connection has been established, a voice says,
"Connected".
• If the connection attempt takes longer than 120 seconds
to complete, it is cancelled and the LEDs go out. In this
case, repeat the steps listed previously under 5.1 Bluetooth
pairing.
All manuals and user guides at all-guides.com
5.2. Automatic Bluetooth connection (after successful
pairing)
• Switch the headset on using the MF button (5). The blue LED
5.3. Bluetooth multipoint connection
This headset can be connected with two Bluetooth-enabled
terminal devices simultaneously.
• First connect the headset with the first terminal device as described in 5.1.
• Then disable Bluetooth on that terminal device.
• Next, connect the headset with the second terminal device as
• Activate Bluetooth on the first terminal device once more. The
Note
• Make sure that your Bluetooth-capable terminal device is on
and Bluetooth is activated.
• Make sure that your Bluetooth-capable terminal device is
visible for other Bluetooth devices.
• For more information, please refer to the operating
instructions of your terminal device.
begins to flash and the headset automatically connects with the
last terminal device used.
Note
• Once the connection has been established, a voice says,
"Connected".
• If the connection attempt takes longer than 120 seconds to
complete, it is cancelled and the LEDs go out. In this case,
repeat the steps listed previously under 5.2.
• It may be necessary to make settings on your terminal device
to enable automatic connection with the paired headset.
Note – Connection impaired
After the headset and terminal device have been paired,
a connection is established automatically. If the Bluetooth
connection is not established automatically, check the
following:
• Check the Bluetooth settings of your terminal device to see
whether Hama BTH RUN or Hama BTH ACTIVE is connected.
If not, repeat the steps listed under 5.1. Bluetooth pairing.
• Check whether obstacles are impairing the range. If so,
move the devices closer together.
• The performance can also be affected by a weak battery.
described in 5.1.
headset now connects to that terminal device automatically.
3