Hama BTH Run Bedienungsanleitung Seite 4

G Operating instruction
Controls and Displays
1. Earphones
2 Microphone
3 Status LEDs
4 Volume +, jump forward one title
5 On/off button, voice control, multifunction button (MF)
6 Volume -, jump backward one title
7 Charging socket
Thank you for choosing a Hama product.
Take your time and read the following instructions and information
completely. Please keep these instructions in a safe place for
future reference. If you sell the device, please pass these operating
instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw
your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package Contents
• 1x Bluetooth stereo headset
• 1x USB charging cable
• 3 pairs of ear cushions (sizes S, M, L)
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial use only.
• Protect the product from dirt, moisture and overheating, and
only use it in a dry environment.
• Do not drop the product and do not expose it to any major
shocks.
• Do not operate the product outside the power limits given in
the specifications.
• Do not open the device or continue to operate it if it becomes
damaged.
• Since the battery is integrated and cannot be removed, you will
need to dispose of the product as a whole. Do this in compliance
with the legal requirements.
• Dispose of packaging material immediately according to locally
applicable regulations.
• Do not modify the product in any way. Doing so voids the
warranty.
2
All manuals and user guides at all-guides.com
4. Getting Started
• The headset is equipped with a rechargeable battery. The battery
• Ensure that the headset is switched off before charging it.
• Begin charging by connecting the included USB charging cable
• Alternatively, you can charge the headset using a suitable USB
• The display lights up constantly in red during the charging
• It takes around 2-3 hours until the battery is completely charged.
• Once the charging process is complete, the LED goes out.
• Disconnect all cable and mains connections after use.
5. Operation
Switching the headset off/on
• Press the MF button (5) until a voice says "Power ON" and the
• To switch it off, press and hold the MF button (5) until a voice
Warning - Battery
• Only use suitable charging devices or USB connections
for charging.
• As a rule, do not charge devices or USB connections that are
defective and do not try to repair them yourself.
• Do not overcharge the product or allow the battery to
completely discharge.
• Avoid storing, charging or using batteries in extreme
temperatures.
• When stored over a long period of time, batteries should be
charged regularly (at least every three months).
Warning - High volumes
• Using this product limits your perception of ambient noise.
For this reason, do not operate any vehicles or machines
while using this product.
• Always keep the volume at a reasonable
level. Loud volumes, even over short
periods, can cause hearing loss.
must be fully charged before using the device for the first time.
to the charging socket (4) as well as to the USB connection
of a PC/laptop.
charger. Please refer to the operating instructions for the USB
charger used.
process.
blue LED flashes.
says "Power OFF" and the red LED flashes.