Troubleshooting - Zelmer ZIS8700 Healthy Benutzerhandbuch

Troubleshooting

Problem
The iron begins to smoke when
switched on.
Water runs out of the
holes in the soleplate.
Dirt comes out through the
soleplate.
The "Calc'nClean" indicator light
(3) does not turn off.
The soleplate is dirty or brown
and may stain the garment. The
clothe sticks
in the soleplate.
The appliance makes a pumping
sound.
Loss of pressure during ironing.
Water spots appear on the
garment during ironing.
The hose gets hot during use.
Water leakage from the boiler.
The "Water tank empty" indicator
light (4) comes on.
If the above tips do not solve the problem, get in touch with our customer service.
Possible cause
During first use: certain components
on the appliance have been lightly
greased at the factory and may
produce a small amount of smoke
when initially heated.
During subsequent use: the soleplate
may be soiled.
Water has condensed in the pipes
because you are using for the first
time or you have not used it for some
time.
There is a build-up of lime scale or
minerals in the iron.
Chemical products or additives have
been used.
The iron descaling process has been
stopped before being completed.
You are ironing at too high
a temperature.
Water is being pumped into the iron.
The steam release button has been
activated for a too long period of time,
meaning it has been pressed too
frequently.
May be caused by steam condensed
on the ironing board.
This is normal. It is caused by the
steam passing through the hose
during steam ironing.
Boiler cap (9) is loose.
The water tank is empty or not
correctly fitted onto the appliance.
Solution
This is completely normal and will
stop after a short while.
Clean the soleplate according to the
cleaning instructions in this manual.
Press the steam trigger away from
your ironing board until the iron
produces steam.
Carry out a cleaning cycle (see the
"Descaling process" section).
Never add products to the water (see
the "Filling the water tank" section).
Clean the soleplate with a damp cloth.
Restart and complete the iron
descaling process.
Adjust the temperature dial to a lower
heat setting.
This is normal.
Use the steam release button at
intervals.
Wipe the textile cover of the ironing
boards, and iron any water drops to
dry them.
Place the hose on the opposite side
so that you do not touch the hose
during ironing.
Tighten the cap.
Fill the water tank or fit it correctly.
EN PL
17