Troubleshooting - Zelmer ZIS6450 Smartcare Benutzerhandbuch

Troubleshooting

Problem
The iron begins to smoke when
switched on.
The iron does not produce any
steam.
Dirt comes out through the
soleplate.
The "Calc'nClean" indicator light
(1) does not turn off.
The appliance makes a pumping
sound.
There is too much steam coming
out of the iron.
The iron produces little steam.
If the above tips do not solve the problem, get in touch with our customer service.
Possible cause
During first use: certain
components on the appliance
have been lightly greased at
the factory and may produce a
small amount of smoke when
initially heated.
During first use, water has not
filled the hose (4) completely.
The "Calc'nClean" indicator
light (1) will flash. The
descaling process has not
been completed.
There is a build-up of lime
scale or minerals in the iron.
Chemical products or
additives have been used.
The iron descaling process
has been stopped before
being completed.
Water is being pumped into
the iron.
The water tank is empty.
Mode BOOST is turned on.
The iron has been switched
on recently.
EN
Solution
This is completely normal and
will stop after a short while.
Press and hold the steam
release button (12) until steam
comes out.
Perform a cleaning cycle
(see the "Descaling process"
section).
Carry out a cleaning cycle
(see the "Descaling process"
section).
Never add products to the
water (see the "Filling the
water tank" section). Clean the
soleplate with a damp cloth.
Restart and complete the iron
descaling process.
This is normal.
Fill the water tank.
Activate the normal mode by
pressing the "ECO/BOOST"
(3) button.
It is normal, the iron produces
steam gradually until it is
stabilized.
15