Cleaning The Appliance; Storing The Appliance - Zelmer ZIS8700 Healthy Benutzerhandbuch

PL EN
7. Replace and tighten up the cap.
Descaling the limescale collector
1. Place the limescale collector (9) under the water tap.
2. Wash it up until limescale residues are removed.
Descaling the iron
1. Fill the tank (10) with water.
2. Plug in the mains cable (7) and press the button (2) to switch the appliance on.
3. Press the descaling button (3) for 2 seconds. Its indicator light will remain permanently lit.
4. Wait until the indicator light (2) stops flashing and remains lit permanently. Two beeps will be heard.
Hold the iron in a horizontal position over an empty sink to collect the water.
Warnings:
Boiling water and steam will be released through the soleplate, removing limescale and/or
deposits that may be inside.
5. Press the steam release button (15) for 2 seconds. The descaling process will start automatically.
During this process, short beeps will be heard.
6. After approximately 3 minutes, the iron will stop releasing steam. A long beep will be heard, indicating
that descaling process has finished. The appliance will switch off automatically.
7. To clean the soleplate (16), immediately rub off any residue by running the hot iron over a wet cotton
cloth. Wipe the housing of the iron with a cloth.

2. Cleaning the appliance

Regularly clean your appliance for properly maintenance.
Attention! Burn risk!
1. If the appliance is only slightly soiled, wipe it with a damp cotton cloth only, and then dry it.
2. If the cloth is synthetic it may melt due to the high temperature on the soleplate. Switch the steam off
and rub off any residue immediately with a thickly folded, damp cotton cloth.
3. To keep the soleplate smooth, you should avoid contact with hard metal objects. Never use a scouring
pad, or chemicals to clean the soleplate.

3.Storing the appliance.

1. Unplug the appliance and let it cool down. Empty the water tank (10).
2. Place the iron on the steam station, standing on the pad (13).
3. Store the mains cable and the supply hose in the storage fixing (8). Do not wrap the cords too tight.
16