Troubleshooting Guide - Zelmer ZIR2415 Benutzerhandbuch

PL EN

Troubleshooting Guide

Please consult troubleshooting table below for any issues you may face prior to contacting our support
center.
Problem
Unit fails to heat up and
steam. Power indicator
light does not illuminate.
Water runs out of the
holes in the soleplate.
White streaks come
through the holes in the
soleplate.
Brown streaks come
through the holes in the
soleplate and stain the
linen.
The soleplate is dirty or
brown and may stain the
garment. The clothe sticks
in the soleplate.
There is no steam or there
is little steam.
14
Possible cause
Unit is not plugged in.
Water has condensed in
the pipes because you are
using for the first time or
you have not used it for
some time.
The soleplate is not hot
enough.
The product has a build-
up of scale because the
anti-calc cartridge has not
been changed regularly.
You are using chemical
descaling agents or
additives in the water for
ironing.
You are ironing at too high
a temperature.
The water tank is empty.
The soleplate is not hot
enough.
Solution
Plug into electrical outlet.
Press the steam trigger away from your
ironing board until the iron produces
steam.
Wait until the iron soleplate is hot enough
or increase the temperature of the
soleplate.
Change the anti-calc cartridge
Never add this type of product in the
water tank or in the steam chamber.
Adjust the temperature dial to a lower
heat setting.
Fill the water tank.
Wait until the iron soleplate is hot enough
or increase the temperature of the
soleplate