Fault Diagnosis; Fault Handling - Creality 3DPrintMill Benutzerhandbuch

Trouble-shooting

Fault diagnosis

Workflow
Start
Play by
memory card
File
Y/N identification
or not
Return
"Home"
Print or
Y/N
not
Heat the
hot bed
Hot bed is
Y/N
heated or not
Heat the
nozzle
Y/N
The nozzle is
heated or not
Printing when
Dislocation
filament push
or not
Filament-
Y/N
push or
The E motor
Finish
rotates or not
Fault cause
Other
Display error
documents
codes or not
are printed
normály or
Beyond
"Home"
The display of
temp is
normal or not
The display of
humidity is
norma lor not
The gear
The filament is
rotates or not
norma lor not

Fault handling

1. Wipe Storage-card
2. Format Storage-card
Storage
3- Replace Storage-card
card
File Change the file name to English and
naming number format
1. Move model position and slice again
Slicer
2. Using repair software to repair the
Shaft 1. Reconnect the circuit
motor 2. Check by substitution
Limit
1. Reconnect the circuit
switch
2. Check by substitution
Hot bed 1. Reconnect the circuit
1. Reconnect the circuit
Thermisto
r
Heat
1. Reconnect the circuit
tube
1. Reconnect the circuit and lock the
Thermisto
screws of thermistor
r
1. Slice again
Slicer/Sync
2. Adjust the tension of the synchronous
hronous
belt
1. Fasten the coupling
Coupling
Others
1. Remove surface detects of filaments
Filament
2. Replace filament
1. Reconnect circuit
E motor
2. Check by substitution
18
Result
Problem
Resolved
Component
damage, replace
Process result
continuously
Unknown
malfunction
, please
contact the
after-sales