Creality 3DPrintMill Benutzerhandbuch Seite 12

Levelling
1. First move the X axis to the contact part between the nozzle and the belt (slightly
press the nozzle onto the belt).
2. Push the two limit switches against the X sliding block to lock the limit;
3. Press back on the screen to get the printer back to the origin; adjust the Y axis end-
stop adjusting screw according to the position of the nozzle relative to the belt after
back to the origin in order to make sure the nozzle contacting with the belt rightly; then
tighten the Y axis end-stop screw, leveling finished;
4. if there is any seam or over contact between the nozzle and the belt, adjust the
leveling nut slightly.
A Y axis end-stop
adjusting screw
B Y axis end-stop
adjusting the screw
12