Inhaltsverzeichnis
Werbung
Manual | Ladesäule Twin
Installation and operation
place of installation
Please be aware that the right place for Installation
should be where the charging inlet to the choosed car
will be. It is recommended that the connected cable
should not lead to stumbling.
Please also consider that exposure to direct
sunlight will lead to reduced charging current
when the internal heat decrease automatically
the current as long as the charger cooles down.
The product consists high quality aluminum and
Plastic. It is recommended to use the optional
mounting plate for installation, which you can
also use for drilling the attachment points into
the concrete foundation (drill pattern).
The charger is particularly suitable for private or semi-public use
vandalism resistance is very high (IK08). An RCD (FI) type A is
required to be installed in the distribution board of the power supply in
every charging point. Other equipment or other types and accessories
can be found on our website.
This is an electrotechnical product which generates waste heat when
used. In the warm season and when operating under full load, the
device can thus heat up. The integrated temperature measurement
then reduces the possible charging power. To avoid this, it is strongly
recommended to not install the charger in a place where it is exposed
to extreme solar radiation.
9
Technische Änderungen unter Vorbehalt | Stand 03/2022 | DB9.0030
Werbung
Inhaltsverzeichnis
