Assembly; Operation - Husqvarna CL400i Bedienungsanweisung

the battery charger. Cleaning and user maintenance
shall not be made by children without supervision.
• Do not charge non-rechargeable batteries in the
battery charger.
• Do not use the battery charger near flammable
materials or materials that can cause corrosion. Do
not cover the battery charger. Pull out the plug to the
battery charger if there is smoke or fire.
• Do not use a defective or damaged battery charger.
• Only charge the battery indoors in a room with good
airflow and away from sunlight. Do not charge the
battery in wet conditions.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
• Remove the safety key before you do maintenance
on the product.
Introduction
WARNING:
safety chapter before you assemble the
product.
To install the drill
1. Put the drill (A) into the drill head (B) and install the
screw (C). (Fig. 16)
Note:
A 6 mm wrench is necessary to install the
drill.
2. Tighten the screw.
To install the cable
The product has a clutched cable winder that can be
removed.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Fleet Services
Husqvarna Fleet Services
gives the operator an overview of all products that
are connected. On this product a Husqvarna Fleet
14
Read the warning
Read and understand the
Before you operate the
™
™
is a cloud solution that
• Do the maintenance work correctly to increase the
lifetime of the product and decrease the risk of
accidents. Let an approved service agent do the
professional repairs. Speak to your nearest service
agent for more information.
• Only do the maintenance work written in this
operator's manual.
• Use heavy duty gloves when you touch the cable
laying equipment.
• Keep the product clean for the best and safest
performance.
• Let your service agent regularly examine the product
and make necessary adjustments and repairs.
• Replace damaged, worn or broken parts.
• Obey the instructions for how to change accessories.
Only use accessories from the manufacturer.
• When not in operation, keep the product, battery and
battery charger apart in a dry, indoor and locked
area. Make sure that children and persons that are
not approved cannot get access to the product,
battery or battery charger.

Assembly

1. Put the cable onto the cable winder. Use the knob to
turn the cable winder clockwise.
Note:
The cable must be installed clockwise on
the cable winder so it unwinds smoothly during
operation.(Fig. 17)
2. Push the cable into the tube in the feeding fin
(A) until the cable comes out from the bottom (B)
approximately 5 cm. (Fig. 18)
To install and remove the cable winder
1. Loosen the knob (A). (Fig. 19)
2. Remove the retainer (B).
3. Remove the cable winder (C).
4. Install the cable winder (D). Use the adapter if it is
necessary. (Fig. 20)
5. Install the retainer (E) and tighten the knob (F).

Operation

™
Services sensor can be installed. The Husqvarna Fleet
™
Services sensor collects product data and lets you
connect to the Husqvarna Fleet Services
Husqvarna Fleet Services
as operation time, servicing intervals and location of the
product.
For more information about Husqvarna Fleet Services
download the Husqvarna Fleet Services
to your Husqvarna representative.
™
system. The
™
system reports data such
™
app or speak
1698 - 001 - 21.01.2022
™
,