Inhaltsverzeichnis; Introduction - Husqvarna CL400i Bedienungsanweisung

Introduction..................................................................... 9
Safety............................................................................10
Assembly...................................................................... 14
Operation...................................................................... 14
Maintenance................................................................. 17
Product description
The product is a pedestrian-controlled cable layer.
Product overview
(Fig. 1)
1. Drill operation bail
2. Handlebar tilt bail
3. Drive bail
4. Counter
5. Cable winder
6. Feeding fin
7. Drill
8. Control panel
9. Safety key
10. Battery (Accessory)
11. Battery charger (Accessory)
12. Operator's manual
Symbols on the product
(Fig. 2)
WARNING
(Fig. 3)
Warning: Rotating parts. Keep hands and
feet away.
(Fig. 4) Look out for thrown objects and ricochets.
(Fig. 5)
Read the instructions.
(Fig. 6)
Keep persons and animals at a safe
distance from the work area.
(Fig. 7) Risk of eye injury to bystanders.
(Fig. 8)
Do not expose to rain.
(Fig. 9)
Use protective visor.
(Fig. 10) Standby mode (black button).
(Fig. 10) Start and stop the motor (red button).
1698 - 001 - 21.01.2022
Contents
Troubleshooting............................................................ 19
Transportation, storage and disposal........................... 21
Technical data.............................................................. 21
Declaration of Conformity............................................. 23

Introduction

Intended use
Use the product to put boundary wire and guide wire
for robotic lawn mowers into the ground. Do not use the
product for other tasks.
(Fig. 11)
(Fig. 12)
(Fig. 13)
Note:
Other symbols/decals on the product refer to
certification requirements for some markets.
Product liability
As referred to in the product liability laws, we are not
liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not
from the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is not repaired at an approved service
center or by an approved authority.
The product or package of the product
is not domestic waste. Recycle it at
a recycling station for electrical and
electronic equipment.
The product agrees with the applicable
EC directives.
Noise emission to the environment
label as per EU and UK directives
and regulations, and New South Wales
legislation "Protection of the Environment
Operations (Noise Control) Regulation
2017". The guaranteed sound power level
of the product is specified in
data on page 21 and on the label.
The product is drip protected.
Technical
9