Safety System; Switching Off A Burner; Power Levels - Siemens er 326 ab 90 e Gebrauchsanweisung

Safety system

Thermocouple

Switching off a burner

Power levels

Ú
Setting
™
Large flame
š
Economy
flame
If it does not come on, turn the control to the off setting
and repeat the steps above. This time, press and hold the
control for longer (up to 10 seconds).
Warning! If after 15 seconds have elapsed, the flame
does not ignite, switch off the burner and open a nearby
window or door. Wait at least one minute before trying to
switch the burner back on.
Depending on the model, your hob may have a safety
system (thermocouple) that prevents the flow of gas if the
burners accidentally switch off. To ensure that this device
is active, switch on the burner as usual and, without
releasing the control, press and hold it down firmly for 4
seconds after lighting the flame.
Ignition sparker
Turn the corresponding control clockwise to the 0 setting.
The progressive control knobs can be used to control the
power needed, from minimum to maximum power.
Control off
Maximum
capacity or
aperture and
electricity
on
Minimum
capacity or
aperture
For dual double-flame burners, the inner and outer
flames can be controlled separately.
The available power levels are as follows:
Inner and outer flame on full power.
Outer flame on minimum, inner flame on full power.
9