After Use; Electrical Connection; Cleaning - Scheppach 5907728901 Original Bedienungsanleitung

7. Place the product with the suction attachment (1)
on top of the surface to be cleaned (e.g. a win-
dow). Slowly move the product down the surface
to be cleaned, making sure that the rubber blade
remains in constant contact with the surface. Wa-
ter and cleaning agent residues are removed and
sucked into the dirty water tank (2).
8. Continue to move across the surface to be
cleaned, slightly overlapping the previous stroke
each time, until the entire surface has been com-
pletely cleaned.
9. WARNING! Move the product from top to bottom.
Do not move the product horizontally when clean-
ing the surfaces.
10. When the water level reaches the maximum lev-
el mark (2g), switch off the product and empty the
dirty water tank (2) (see 9.7).
ATTENTION!
• Make sure you apply appropriate pressure on the
surface to be cleaned, to avoid damaging the sur-
face.
• Avoid liquid running down the surface you are clean-
ing.
• Do not use the product on uneven surfaces, such as
frosted glass, textured or patterned glass, etc.
• Do not use the product to clean cracked or broken
surfaces.

10.2 After use

1. Press the on/off switch (5) to switch off the product.
2. Remove and empty the dirty water tank (2) if nec-
essary.
3. Inspect, clean and store the product as described.

11. Electrical connection

The electrical motor installed is connected and ready
for operation. The connection complies with the appli-
cable VDE and DIN provisions.
The customer's mains connection as well as the ex-
tension cable used must also comply with these reg-
ulations.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables of the same designation.
The printing of the type designation on the connection
cable is mandatory.

12. Cleaning

WARNING! Always switch off the product and let it cool
down before carrying out any cleaning work!
• Keep the product as free of dust and dirt as possible.
We recommend that you clean the product directly
after every use. Regular and proper cleaning helps
to ensure safe use and prolongs the service life of
the product.
• Clean the product at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the product.
• Make sure that no water can penetrate the product
interior.
Microfibre cloth
1. Remove the microfibre cloth (6) in reverse order to
that described in 9.1.
2. Clean the microfibre cloth (6) with fresh water and
mild soap.
www.scheppach.com GB | 29