Driver Installation; All Operating Systems; Cleaning - Exsys EX-1186HMVS-2 Anleitung

EX-1186HMVS-2
4. Hardware Installation
2. Now connect the USB cable to the USB B-Port at the Hub.
3. Connect the optional power supply with the DC-Jack or the Terminal Block at the Hub.
4. Last connect the other end of the USB cable (A-Plug) to the A-Port at your PC.

5. Driver Installation

All Operating Systems

After the hardware installation the OS will recognize the device automatically and install the driv-
ers.
CHECK INSTALLED DRIVER
Open the >Device manager<. Now you should see at „USB-Controller" the following new entry's:
If you see this or a similar information the device is installed correctly.

6. Cleaning

For cleaning please use only a dry fluff less cloth and remove the dirt with gently pressure. In the
area of the connectors please make sure that no fibres from the cloth remain in the connectors.
Attention! Never use a moist or wet cloth for cleaning!
© Copyright 2021 by EXSYS Vertriebs GmbH. All Rights Reserved
11
Deutsch