Initial Operation - Bosch GIM 60 L Professional Originalbetriebsanleitung

OBJ_BUCH-1628-003.book Page 16 Wednesday, March 19, 2014 9:40 AM
16 | English
Connect the battery to the battery tray observing the correct polarity. Insert
the battery lid with the battery tray into the measuring tool in such a manner
that the connection cables are not pinched.
When switching on the grade measurement for the first time after changing
the battery, all display elements light up for 1 s and an audio signal sounds.
All saved settings (measuring mode, set unit of measure) are deleted when
changing the battery.
When the battery low indicator d lights up, the battery must be replaced.
Inserting/Replacing the Batteries for the Laser
Fold out the battery lid 20 and insert the batteries. When inserting, pay at-
tention to the correct polarity according to the representation on the inside
of the battery lid.
When the laser no longer lights up, the batteries must be replaced.
Note: The battery low indicator d on the display does not refer to the laser
batteries.
 Make sure to switch the laser off before changing the batteries. An
accidentally switched on laser can blind other persons.
Always replace all batteries intended for laser operation at the same time.
Only use same-brand battery with the identical battery capacity.
Operation

Initial Operation

 Protect the measuring tool against moisture and direct sun light.
 Do not subject the measuring tool to extreme temperatures or vari-
ations in temperature. As an example, do not leave it in vehicles for
longer periods. In case of large variations in temperature, allow the
measuring tool to adjust to the ambient temperature before putting it in-
to operation.
 Avoid heavy impact to or falling down of the measuring tool. After se-
vere exterior effects to the measuring tool, it is recommended to carry
out an accuracy check (see "Accuracy Check and Calibration of the Meas-
uring Tool", page 18) each time before continuing to work.
 Keep the supporting surfaces of the measuring tool clean and pro-
tect them against impact and shock. Debris particles or deformations
can lead to faulty measurements.
Setting Up/Attaching the Measuring Tool
To measure or transfer grades, the measuring tool can not only be placed on
or against surfaces, but can also be set up or fastened in various ways.
Setting up with the levelling mechanics (e.g. on uneven floors)
(see figure B):
– Briefly press against the pedestal 16 to extract it. Press button 8 to ex-
tract the levelling foot 17. Adjust the height of the levelling foot by turn-
ing adjusting screw 9 so that the laser beam runs along the surface to be
measured or the desired grade is displayed as the measuring value b.
– For work without levelling mechanics, retract pedestal 16 and levelling
foot 17. For this, press both parts of the pedestal () together and then
slide the pedestal 16 into the measuring tool () until it can be heard to
engage. To retract the levelling foot 17, press switch 10 sideways.
Fastening to the tripod:
– Position the measuring tool with the 1/4" tripod mount 18 onto the
quick-change plate of the tripod 26 or a commercially available camera
tripod. Tighten the measuring tool with the quick-change plate locking
screw.
Attachment with magnets:
– Place the measuring tool against an adequate magnetic object via the
magnets 14.
1 609 92A 0KV | (19.3.14) Bosch Power Tools