Electrolux GK58TSITO Benutzerinformation Seite 21

Problem
You cannot select the
maximum heat setting
for one of the cooking
zones.
An acoustic signal
sounds and the hob de‐
activates.
An acoustic signal
sounds when the hob is
deactivated.
The hob deactivates.
Residual heat indicator
does not come on.
Hob²Hood does not
work.
The sensor fields be‐
come hot.
There is no sound when
you touch the panel sen‐
sor fields.
comes on.
The control bar blinks.
Possible cause
You do not set the heat
setting for 10 seconds.
You touched 2 or more
sensor fields at the same
time.
Pause operates.
There is water or fat stains
on the control panel.
The other zones consume
the maximum available
power.
Your hob works properly.
You put something on one
or more sensor fields.
You put something on the
control panel.
The zone is not hot be‐
cause it operated only for a
short time or the sensor is
damaged.
You covered the control
panel.
You use a very tall pot
which blocks the signal.
The cookware is too large
or you put it too near to the
controls.
The sounds are deactiva‐
ted.
Child Safety Device or
Lock operates.
There is no cookware on
the zone or the zone is not
fully covered.
ENGLISH
Remedy
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Refer to "Additional func‐
tions".
Clean the control panel.
Reduce the heat setting of
the other cooking zones con‐
nected to the same phase.
Refer to "Power manage‐
ment".
Remove the object from the
sensor fields.
Remove the object from the
control panel.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Remove the object from the
control panel.
Use a smaller pot, change
the cooking zone or operate
the hood manually.
Put large cookware on the
rear zones, if possible.
Activate the sounds. Refer to
"Additional functions".
Refer to "Additional func‐
tions".
Put cookware on the zone so
that it fully covers the cook‐
ing zone.
21