Clock; Steering Wheel Remote Control (Swc); Settings | Menu - Blaupunkt 400-Serie Bedienungsanleitung

15. Clock

The unit has an internal clock so you can view the time on the
display by pressing the DIS button until the desired
information appears.
The time can also be displayed when the unit is turned off, see
"SETTINGS".

16. Steering wheel remote control (SWC)

You can assign the steering wheel remote control buttons (if
available) to the existing functions in the unit's SWC
configuration.
Storing functions
Open VARIOUS -> SWC in the device settings.
Then, with the right button/knob select the function you wish
to programme and confirm with the right button/knob.
The unit will now wait for a signal from the steering wheel
remote control and display PRESS KEY AT STEERING WHEEL
CONTROL FOR 1SEC. Press the desired button on the steering
wheel remote control.
If the button has been successfully programmed, the display
will show OK. Repeat the procedure if the unit displays FAIL or
does not respond at all.
Repeat this step for all buttons to be programmed.

17. Settings | Menu

Select the settings by pressing the MENU button. Turn the
right button/knob to navigate through the settings or change
a setting.
To select an option or change a setting select it by briefly
pressing the right button/knob.
Press and hold the right button/knob or select <<< to move
up one level again; select <<< at the highest level to exit the
settings menu. You can also exit the settings menu by pressing
the MENU button again.
The following settings can be entered or customised (the
settings are arranged by different categories):
TUNER (RADIO):
In this submenu you can make settings for the radio receiver.
TRAF:
Enable/disable traffic message prioritisation.
When this function is activated, the unit will switch
to the radio station last heard and then back to the
previously active source after receiving a traffic
announcement. When the function is active, a small
symbol with three vehicles appears on the display.
TRAFFIC (VERKEHR) appears on the display during
a traffic message.
Note: This feature must be supported by the
radio station.
To display the time when the unit is off the vehicle's ignition
must be on; if the ignition is off, the display turns off
completely to reduce power consumption.
To set the clock see "SETTINGS".
Note: If storing is not possible even after several attempts
or is not performed correctly, check the device connections or
the compatibility of the interface used. If FAIL is always
displayed, the error is probably in the remote control or in the
interface. If the unit does not respond at all, make sure that the
remote control/interface is (properly) connected.
Note: The programmable SWC interface of this device
includes analogue steering wheel presets. The device works
with analogue remote controls that control functions through
different resistance values (resistance matrix) at the connector
(up to two control lines and 1x GND).
Some remote controls are directly compatible, others require a
SWC interface. The steering wheel remote controls cannot be
connected without an interface via CAN.
For more information on the accessories suitable for your
vehicle, contact your specialist dealer or the vehicle
manufacturer.
Note: To adjust the volume, refer to the
VOLUME (LAUTSTAERKE) menu option.
Note: If the reception of a radio station is
interrupted, the unit automatically seeks a new
station with traffic information. Enabling this
feature also limits your search to the stations that
support this feature.
Note: The current traffic announcement can be
interrupted by pressing the SRC button.
REG:
When this function is on, only stations with the
same regional programme are selected if automatic
station switching is required due to poor reception.
Note: The RDS AF function must be set to ON
(EIN), the function must be supported by the radio
station.
PTY:
When this function is enabled, the PTY function is
also available by pressing the right button/knob to
search for a specific type of station/music genre.
PTY TYPES (PTY LISTE):
Active only when PTY is ON (EIN).
Selects the station type/music genre for the PTY
function.