Setting Up The Wantec Door Intercom - PEAKnx wantec Monolith C IP Kurzanleitung

2 Setting up the wantec door intercom

2 Setting up the wantec door intercom
1. Connect the wantec device to a PoE-enabled switch on your network.
2. To be able to set up the Monolith C IP, you must enter its IP address into your browser. It is
also specified in the instructions of the door station, e.g.: 192.168.1.250.
− At fritz.box under Overview > Home network, the active clients/devices are displayed.
Here you will also find the IP address of the door intercom. Enter it in the browser to reach
the configuration page of the door station.
− Depending on the configuration of your network, at least the fourth digit sequence of the
IP address should match those of the instructions.
3. Enter the displayed IP address in the browser to configure the wantec door station.
4. The camera stream is displayed. Scroll down and click „Setup".
5. The default user name is: „admin", the password is „1234".
6. You can set the languages at the top right corner of the page.
7. Under Network Setting > SIP parameters, under „SIP mode:", select „SIP server".
8. Under „Account" and „Password", enter the authentication name and the password which
you have assigned for the wantec door station in the Fritzbox.
− You can also find your login data and registrar (Registration server) under fritz.box >
17