Stick Calibration; Power Off - Absima Cr4S Bedienungsanleitung

4.4 Stick Calibration

This function is used to set the neutral position for throttle and wheel.
Ever y transmitter is calibrated before leaving the factor y, however if recalibration is required,
please follow these steps:
1. Tur n and hold the wheel as far clockwise a s it will t ur n , hol d th e t hrott l e al l t he way for wa rd,
then tur n on the transmitter in calibration mod e.
• The R.LED and G.LED will flash twice.
2. C al ibrate wheel: Tu r n the whee l complete ly clockwise , t h en com pl ete l y co un te rc l o c k wi s e.
When calibration is completed the R.LED will be off.
•
3. Tr igger calibration: Pull the trigger ba ck th en for ward as far as i t w i l l go.
• When calibration is completed the G.LED will be off.
4. Once cal ibration is complete press t he bind ke y to sav e an d exi t .

4.5 Power Off

Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Toggle the transmitter's power switch to the off position.
Make sure to disconnect the receiver power before turning off the transmitter.
•
Danger
Failure to do so may lead to damage or serious injury.