Getting Started; Transmitter Battery Installation; Battery Cover - Absima Cr4S Bedienungsanleitung

3.Getting Started

Before operation, install the battery and connect the system as instructed below.

3.1 Transmitter Battery Installation

Only use specified battery.
Danger •
Danger • Do not open, disassemble, or attempt to repair the battery.
Danger • Do not crush/puncture the battery, or short the external contacts.
Danger • Do not expose to excessive heat or liquids.
Danger • Do not drop the battery or expose to strong shocks or vibrations.
Danger Always store the battery in a cool, dry place.
•
Danger • Do not use the battery if damaged.
Battery Type: LR6 "AA" size
Battery Installation:
1. Open the battery compartment cover.
2. Insert 4 fully-charged "AA" batteries into the compartment.
Make sure that the battery makes good contact with the
battery compartment's contacts.
Plug-in a 2S Lipo rechargeable battery (Absima's
item no.4140016)
3. Replace battery compartment cover.

Battery cover

Slide to open
Low batter y alarm: When the batter y is lower than 4.2v,
the G.LED on the panel will flash slowly.
Note: When installing the batteries, be careful to handle the
positive and negative poles. (A s shown in the picture on the right)
or 2S Lipo rechargeable battery
OR
LR6 "AA" size
1.5V LR6 (AA)
1.5V LR6 (AA)
1.5V LR6 (AA)
1.5V LR6 (AA)
rechargeable battery
Plug-in