Instructions; Power On; Binding; Led - Absima Cr4S Bedienungsanleitung

4.Instructions

After setting up, follow the instructions below to operate the system.

4.1 Power On

Follow the steps below to turn on the transmitter :
1. Check to make sure that that batter y is fully charged and installed correctly.
2. Toggle the switch to the [ON] position. When active the R.LED will be lit.
3. Connect the receiver to power.
• For safety always power on the transmitter before the receiver.
Note • Operate with caution in order to avoid damage or injury.
Note • Make sure that the throttle is at its lowest position and the switches are set to their up position.

4.2 LED

1. R.LED: Red power indicator ;
2. G.LED: Green status indicator ;
3. Low batter y alarm: When the batter y is lower than 4.2v, the G.LED on the panel will flash slowly.

4.3 Binding

The transmitter and receiver have already been bound at the factor y.
However if the receiver needs to be replaced or additional receivers bound follow these steps:
1 . Tu r n o n t h e t ra n s m i tte r w h i l e h o l d i n g t h e b i n d b u tto n to e n te r b i n d m o d e . G . L E D w i l l sta r t
flashi ng qu ickly.
• Once in bind mode release the bind button.
2. T he rece iver w ill e nter bind mode atomically when p owered on .
3 . O n ce b i n d i n g i s s u cce s s f u l t h e re ce i ve r ' s L E D w i l l fl a s h s l o w l y a n d t h e t ra n s m i tte r ' s L E D
wi ll remai n solid after being rebooted.
Note: W hen bind ing , put the transmitter into b in d mode first , t h e n t h e rece i ver.
applicable to the CR4S transmitter and the R4WP receiver. Different receivers have
•
different bind procedures. For more information visit the ABSIMA website for manuals and
other related information.
Product information is updated regularly, please visit our website for more information.
•
5