Additional Settings; Remote Diagnostics - Bosch CTL636E 6 Serie Gebrauchsanleitung

en Home Connect

Additional settings

Home Connect can be adapted to your
individual needs at any time.
Note: The fully automatic coffee machine
must be connected to the WLAN network.
Disconnecting
The fully automatic coffee machine can be
disconnected from the WLAN network at
any time.
F
If the fully automatic coffee machine
is disconnected from the WLAN
network, it cannot be operated using
Home Connect�
■ Touch A to open the menu�
■ Touch [ Home Connect ] �
■ Touch [ Disconnect from network ]�
The connection to the network and app is
disconnected� Wi-Fi and remote start are
switched off.
F
Information about the WLAN network
is cleared.
Connecting with app
The Home Connect app can be installed on
any number of mobile devices, which can
then be used to connect to the fully auto-
matic coffee machine.
The fully automatic coffee machine must
already be connected to the WLAN network.
■ Open the app on the mobile device.
■ Touch A to open the menu�
■ Touch [ Home Connect ] �
■ Touch [ Connect with app ] to connect to
the appliance with the app.
Remote start
If you wish e.g. to start drinks dispensing
on the fully automatic coffee machine via
a mobile device, Remote start must be
activated�
54
B
Risk of burns!
If an unattended remote start takes
place, third parties might be scalded
if they reach under the coffee dis-
penser during drinks dispensing. You
should therefore make sure that with
an unattended remote start that there
is no risk to other people, in particu-
lar not to children, or to property.
F
The [ R emote start ] text field is is
only visible if connection with Home
Connect has been successfully
completed.
F
If Remote start is switched off, only
the modes of the fully automatic
coffee machine are displayed in the
Home Connect app�
■ Touch A to open the menu�
■ Touch [ Home Connect ] �
■ Touch [ Remote start ] to switch the func-
tion Remote start "On" and "Off"�
Device Info
Display for network and device information
■ Touch A to open the menu�
■ Touch [ Home Connect ] �
■ Touch [ a ppliance Info ] . The SSID, IP, MAC
address and serial number of the appli-
ance are displayed for a few seconds.
Display
The top right­hand corner of the display
shows the Home Connect status with a
symbol:
Connected to the network
Not connected to the network
No connection to server

Remote diagnostics

In the event of faults, customer service
can use remote diagnostics to access your
appliance. Contact customer service and
ensure that your appliance is connected to
the Home Connect server and check that
the remote diagnostics service is available
in your country.