Yard Force NX 60i Installationsanleitung Seite 9

GB
Sensor setting
1. Press the button to enter the menu setting.
Timer Sensor PIN English
1 2 3 4
2. Press the button to enter the sensor setting.
Sensor Settings
UltraSonic Rain Voice
1 2 3
Only for NX 100i
- UltraSonic sensor
This machine equipped 2 ultrasonic sensors which may detect the obstacle on the lawn. When the
sensor is actived, the robot will stop and then turn around when detect an obstacle.
Press to switch off the sensor.
Press to elect the detect distance you require.
- Rain sensor
NOTE: Mowing in the rain is not recommended.
This machine has a rain sensor which may stop the robot from mowing in the rain. When the
rain sensor is triggered, the robot will go back to the charging station first, where it will be fully
charged. Once charged the mower will remain in the charging station until the rain has stopped
before starting to mow again.
Note: Be careful not to short circuit the sensors on the machine with any metal objects. This will
cause the mower to work abnormally.
Press to switch off the sensor.
Press to set the extra time.
PIN code
1. Press the button to enter the menu setting.
Timer Sensor PIN English
1 2 3 4
2. Press the button to enter the PIN setting.
- This option sets the passcode of the mower to prevent theft or unauthorised change of the
menu settings. The existing (old) passcode is required to change to a new passcode. If you have
forgotten the passcode, contact your local dealer or after sales service.
The default passcode of the mower is "0000".
UltraSonic Setting UltraSonic Setting
ON OFF Settings
30 cm (30-60)
1 2 3
Raning Setting Delay Time In Charging
OFF
ON Settings
002 minute
1 2 3
Voice Setting
ON OFF
1 2
12
Enter Old PIN Code
* * * *
2
1
- After re- enter the new PIN, press button OK complete this setting.
Language
1. Press the button to enter the menu setting.
2. Select related number to set the language you require.
Current Language Setting
English Svenska Deutsh
1 2 3 5
WiFi settings
Press the button to enter the menu setting.
WiFi
Config Status Mode
1 2 3
There are 3 further options in "WiFi".
Config
Select this option when you need to connect you mower to APP, see APP manual
Status
Show currently WiFi status
Mode
Client Mode-Default mode
Direct Mode-select this mode when you choose direct mode connection you on your phone.
Signal setting
- Set you require signal by pressing S1 or S2 button.
Enter New PIN Code
* * * *
Re-Enter New PIN Code
* * * *