General Power Tool Safety Warnings - Makita RP0900 Betriebsanleitung

ENGLISH (Original instructions)
1. Stopper pole
2. Screw
3. Lock lever
4. Depth pointer
5. Adjusting hex bolt
6. Stopper block
7. Switch trigger
8. Collet nut
9. Collet cone
SPECIFICATIONS
Collet chuck capacity
Plunge capacity
No load speed (min
Overall height
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Intended use
The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
ROUTER SAFETY WARNINGS
1. Hold the power tool by insulated gripping surfaces
only, because the cutter may contact its own cord.
Cutting a "live" wire may make exposed metal parts of
6
Explanation of general view
10. Workpiece
11. Bit revolving direction
12. View from the top of the tool
13. Feed direction
14. Straight guide
15. Guide bar
16. Clamp screw
17. Base
18. Templet guide
Model
-1
)
Net weight
Safety class
the power tool "live" and could give the operator an
ENE010-1
electric shock.
2. Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
ENF002-2
the work by your hand or against the body leaves it
unstable and may lead to loss of control.
3. The cutter bit shank must match the designed
collet chuck.
4. Only use a bit that is rated at least equal to the
maximum speed marked on the tool.
5. Wear hearing protection during extended period of
operation.
6. Handle the router bits very carefully.
GEA010-2
7. Check the router bit carefully for cracks or
damage before operation. Replace cracked or
damaged bit immediately.
8. Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
9. Hold the tool firmly with both hands.
10. Keep hands away from rotating parts.
11. Make sure the router bit is not contacting the
workpiece before the switch is turned on.
12. Before using the tool on an actual workpiece, let it
run for a while. Watch for vibration or wobbling
that could indicate improperly installed bit.
13. Be careful of the router bit rotating direction and
the feed direction.
14. Do not leave the tool running. Operate the tool
only when hand-held.
15. Always switch off and wait for the router bit to
GEB018-5
come to a complete stop before removing the tool
from workpiece.
19. Bit
20. Templet
21. Distance (X)
22. Outside diameter of the templet
guide
23. Dust nozzle
24. Thumb screw
RP0900
6mm, 1/4", 8 mm and/or 3/8"
0 - 35 mm
27,000
217 mm
2.7 kg
/II