Inspection Plan - Hailo M80 Gebrauchsanleitung

13. Inspection plan

• There exists the risk of a fall due to damaged,
defective or non- functional ladder units; there is
also a risk of tipping over when using the ladder.
• Users of the ladder can sustain serious injuries
during a fall.
• Objects can likewise be damaged if the ladder
tips over.
• Regular inspection by a qualified person is
required for commercial use.
• The contractor has to ensure that ladders are
inspected recurrently for proper condition (visual
and functional inspection).
For this purpose, the type, scope and time periods
of the required inspections must be determined.
• The time intervals for the inspection will conform
to the operating conditions, in particular the
frequency of use and demands during use as
well as the frequency and severity of established
defects during the preceding inspections.
• The contractor also has to ensure that defective
ladders are removed from use and stored in such
a way that further use is not possible until proper
maintenance or disposal takes place.
1.
4.
6.
2.
5.
During the regular inspection of the ladder,
inspection points 1-6 should be taken into account.
If any of the tested points cannot be fully satisfied,
you should NOT use the ladder.
1. General inspection points
Are there any contaminants (e.g., dirt, mud,
paint, oil or grease) on the ladder?
All fastenings (rivets, screws, bolts, etc.) must be
completely present.
Are any fastenings possibly loose or corroded?
2. Ladder leg, foldable ladder part, ladder rung
Are the ladder side rails possibly bent, bowed,
twisted, dented, cracked or corroded or rotten?
Check that the foldable ladder part/ladder legs
around the fixing points for other components are
in good condition.
All ladder rungs must be completely present.
Are ladder rungs possibly worn out, loose, cor-
roded or damaged?
Inspect technical condition and functioning of
the extendable ladder legs.
3. Hinge joints
Inspection of functionality, tightness and
completeness as well as damage and corrosion.
Is the hinge joint possibly damaged, loose or
corroded?
4. Locking clamp
Inspection of functionality, tightness and
completeness as well as damage and corrosion.
3.
Are locking clamps possibly damaged, loose or
corroded?
2.
5. Crossbar, feet
Inspect crossbar and feet for tightness as well as
damage and corrosion.
All ladder feet must be present.
Are any ladder feet loose, worn out or corroded?
5.
6. Ladder labels
Are all labels present and perfectly legible?
en
29