Setting Up And Using The Elise 2; Charging The Battery - TensCare Elise 2 Bedienungsanleitung

12. SETTING UP AND
USING THE ELISE 2
12.1. CHARGING THE
BATTERY
The Elise 2 is powered by a type BL4B
rechargeable Li-ion battery. A power
adaptor with an interchangeable plug is
also included in the kit. The battery
should need charging about once a
month. The battery should last at least
15 hours at 50 mA, 300 μs, 50 Hz.
Unused batteries have a nominal shelf
life of 1 year, but will usually last linger
than this. To fully charge the battery it
will take about 2 hours.
When the battery is running low, the
word BATT will show on the screen.
Although the display fades as the
batteries run down, the strength of the
output does not change until the
warning is shown.
Note: The device comes with
the battery already inside.
Avoid removing the battery
cover on the back unless absolutely
necessary. A replacement
cover is required if the original cover is
removed.
Warning:
charger supplied. Use of other
chargers could be hazardous
and will negate the warranty.
To charge the battery:
Connect the charger to the unit and
plug it into the mains socket.
battery
Use only the
19
The word "BATT" will appear on the
charging display – that means the
battery is being charged.
When the battery is charged, the word
will change from "BATT" to "FULL".
Note: The device should be
charged at least once every 3
months to ensure the battery
life is maintained.
Note: The device cannot be
used while being charged.
Note: Charging voltage: DC
5V, charging current: 60mA.
Note: Use adapters of the
following specifications.
• Output: DC 5 V; 1A
• Rated input voltage shall not
exceed 250 V
• Classification
against electric shock: Class II
• IP classification: at least IP21
• The adapter need to comply
with IEC 60601-1 or IEC
60950-1
Battery Warnings
This product is equipped with a Lithium-
ion battery. Failure to follow these
instructions could cause the lithium-ion
battery to leak acid, become hot,
explode or ignite and cause injury and
/or damage:
Do NOT pierce, open, disassemble, or
use in a humid and/or corrosive
environment.
Do NOT expose to temperatures over
60°C(140F).
Do NOT
put,
leave near sources of heat, in direct
of protection
store or