Low Battery - TensCare Elise 2 Bedienungsanleitung

TREATMENT TIMER
The button marked T can be
T
used to set the session duration.
When you switch the unit on, it is
automatically set at 20 minutes.
To set a different time, set the strength
to zero and press T. The min display
will flash.
You can set session times of 10, 20, 30,
45, 60 or 90 minutes with the T button.
The C (Continuous) session timer is
ONLY available
programme.
The LCD shows the session duration in
minutes. The unit automatically counts
down the minutes set and switches off
when it reaches 0.
If you hold down this key for 3 to 5
seconds, you can pause the timer,
allowing you to interrupt the treatment
session, and resume it later. Return to
main screen by pressing any other key.

LOW BATTERY

When the battery is running low, the
word BATT will show on the screen.
Although the display fades as the
batteries run down, the strength of the
output does not change until the
warning is shown.
LEADS ALARM
The Elise 2 monitors the connection
and the contact between you and the
probe, or the pads. This is to prevent
sudden changes if a broken connection
is re-made. If either of these goes
outside of a standard range while the
strength is above 20.0 mA, the unit will
flash LEADS, bleep three times, and
return the strength to 00.0 mA.
for the Urge
18
Check the lead and if necessary,
lubricate the probe with a water based
lubricant such as TensCare Go Gel
(see K-GO). Please see section 19 for
more troubleshooting tips.
MEMORY
The Elise 2 has a Memory with three
functions:
1) Programme Retention. When you
switch the unit on, it will automatically
start in the programme which was being
used when it was switched off.
2) Usage. To activate hold down the T
and + buttons together for 3 to 5
seconds. The display will show the total
duration of use in 10 minute intervals
(where 1=10 minutes, 2=20 minutes
etc.) and the average strength used.
Press the same buttons again to return
to normal controls.
3) Memory Reset. To reset memory to
zero, hold down the T and OFF buttons
together for 3 to 5 seconds.
Time used
in 10 minute
intervals
Average
strength