Herunterladen Inhalt Inhalt Diese Seite drucken

Sunny Health & Fitness PRO II SF-B1964 Bedienungsanleitung Seite 18

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ADJUSTMENT GUIDE
ADJUSTING THE BALANCE:
In order to achieve a smooth and comfortable ride during use, you
must ensure the stability of the bike. If you notice that the bike is
unbalanced, you can adjust the Foot Pads (No. 84) located beneath
the Front & Rear Stabilizers (No. 2 & No. 3).
To do so, use the Spanner (No. 104) to loosen the Hex Nut (No.
41) by turning it clockwise (direction A). With the nut loosened,
rotate the Foot Pad (No. 84) until it sits level with the surface that
the bike is on. When you have finished adjusting the Foot Pads
(No. 84), re-tighten the Hex Nut (No. 41) by turning it counter-
clockwise (direction B) using Spanner (No. 104). If required, repeat
this process to adjust the remaining Foot Pads (No. 84).
RESISTANCE AND BRAKING:
You may adjust the tension level of the bike by rotating the Tension
Knob (No. 90). To increase the level of resistance, rotate the knob
clockwise. To decrease the level of resistance, rotate the knob
counter-clockwise.
During an exercise, you may stop the bike immediately by pushing-
down on the Tension Knob (No. 90). This is the emergency brake.
ADJUSTING THE HANDLEBAR:
It is important that the handlebar and seat are both set to the correct
height of your body. To adjust the handlebar height, loosen and pull
the Pop-pin Knob (No. 91) outward, then slide the Handlebar Post
(No. 6) up or down to the desired height. Once adjusted re-insert
and tighten the Pop-pin Knob (No. 91) to secure the Handlebar
Post (No. 6) in place.
TRANSPORTING THE BIKE:
To move the bike, first ensure that the Handlebar (No. 7) is properly
secured. If the Handlebar (No. 7) is loose, tighten the Pop-Pin
Knob (No. 91) to secure it. Next, stand at the front of the bike so
that you're directly in front of the Handlebar (No. 7). Firmly grasp
and hold each side of the Handlebar (No. 7), place one foot on the
front base and tilt the bike towards you until the Transport Wheels
(No. 83) on the Front Stabilizers (No. 2) touch the ground. With the
Transport Wheels (No. 83) on the ground, you can transport the
bike to the desired location with ease.
NOTE: When moving the bike, always use caution as unexpected
impact, such as dropping the bike, may cause injury and affect the
bike's performance.
17

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis