Description - Eaton 2400-Serie Installationsanleitung

EATON
2.0

Description

The 2400 & 1400 series camera assemblies have been developed to meet the rigorous
requirements of Flame proof and dust-ignition-proof electrical equipment for installation and use
in hazardous locations found in the onshore and offshore, oil & gas and petro-chemical
installations. The units may also be used in marine and industrial hazardous environments.
The housing body and all external parts are manufactured entirely of AISI 316L stainless steel for
low maintenance and protection from corrosion.
Each of the main end covers is fixed to the body by five (5), M6 x 16-mm stainless steel hex cap
screws, with the cable entry cover of the XP and XT systems using five M5 x 12-mm stainless
steel hex cap screws; all conforming to the requirements of EN60079-0:2012/IEC 60079-0:2011.
The weatherproof seal of the union between the body and end covers is maintained by use of 'O'
ring seals fitted in purpose made grooves.
The camera housings feature an internal sliding camera mounting rail which is fitted with an
internal heating element/de-mister, thermostatically controlled, to maintain operating
temperature, and ensure clarity of vision through the window, together with the optional
integral window wiper mechanism.
The viewing window is made with toughened glass, or in the case of the Thermal Imager and
Dual Imager versions, is made from Infra red transparent material and which is factory fitted with
a mechanical window guard.
The mechanical thermal window guard MUST not be removed.
There are four system types that are made up from different combinations of the 2400 and 1400
series certified units; these are:
XF series, fixed camera housings.
XC series, P&T units with integral tilt shaft only.
XP series, P&T units with integral pan and tilt shafts and a fixed base section for cable
connection.
XT series, P&T units with integral pan and tilt shafts and a fixed base section for cable
connection, also a secondary housing for integrated illuminator.
The XF series fixed housings comprise a single tube section with either 3 cable entries in the rear
cover or 1 in the side (model dependant).
The XC series comprise a camera housing fixed to a P&T unit via an integrated tilt shaft; there are
3 cable entries in the rear cover of the housing or 1 into the blank side of the T unit (model
dependant).
The XP and XT units have a single cable entry into the fixed base section, this prevents any
trailing cables.
The 2400 & 1400 series housings and integrated pan/tilt units have been designed and certified
to the ATEX Directive 2014/34/EU and IECEX, with the ratings as detailed in:
Section 6.0
Note: T class and ambient temperature, is dependent on the assembly configuration and
maximum internal power dissipation.
© 2018, Eaton
Installation & Maintenance Instructions
Specifications, Technical data & Special conditions for safe use.
IMI+70-XF-XC-XP-XT Issue 8
Page 5 of 43