Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EATON
Fig.17 Removing the rear flange
Warning : This cover must not under any circumstances be removed until at least 5 minutes
after the disconnection of power source.
3.3.4
XC & XF Common Connection Examples
Always refer to project specific drawings and information
© 2018, Eaton
Installation & Maintenance Instructions
IMI+70-XF-XC-XP-XT Issue 8
Remove the rear flange by first
removing the 5 x M6 screws
and then carefully extracting
the flange.
Next slide out the camera
mounting rail to reveal the
incoming cable connection
terminals.
Page 16 of 43
Werbung
Kapitel
Inhaltsverzeichnis
