Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EATON
2.0
Description
The S series Camera housings and pan/tilt camera assemblies have been developed to meet the
rigorous requirements of non-hazardous locations found in onshore and offshore, oil and gas,
petro-chemical installations, marine and industrial environments.
The housing body and all external parts are manufactured entirely of AISI 316L stainless steel for
low maintenance and protection from corrosion.
Each of the main end covers is fixed to the body by five (5), M5 x 12-mm stainless steel button
screws, with the cable entry cover of the SP and ST systems using five M5 x 12-mm stainless steel
hex cap screws.
The weatherproof seal of the union between the body and end covers is maintained by use of 'O'
ring seals fitted in purpose made grooves.
The camera housings feature an internal sliding camera mounting rail which is fitted with an
internal heating element/de-mister, thermostatically controlled, to maintain operating
temperature, and ensure clarity of vision through the window, together with the optional
integral window wiper mechanism.
The viewing window is made with toughened glass, or in the case of the Thermal Imager and
Dual Imager versions, is made from Infra red transparent material.
There are four system types that are made up from different combinations of housing and P&T
SF series, fixed camera housings.
SC series, P&T units with integral tilt shaft only.
SP series, P&T units with integral pan and tilt shafts and a fixed base section for cable
connection.
ST series, P&T units with integral pan and tilt shafts and a fixed base section for cable
connection, also a secondary housing for integrated illuminator.
The SF series fixed housings comprise a single tube section with 3 cable entries in the rear cover.
The SC series comprise a camera housing fixed to a P&T unit via an integrated tilt shaft; there are
3 cable entries in the rear cover of the housing or 1 into the blank side of the T unit (model
dependant).
The SP and ST units have a single cable entry into the fixed base section, this prevents any trailing
cables.
© 2018, EATON
Installation Instructions
IM-SF-SC-SP-ST Issue 4
Page 5 of 40
Werbung
Kapitel
Inhaltsverzeichnis
