EATON
3.3.2
Washer Nozzle Installation
A continuous rotation P&T system, if supplied with an external washer unit, is supplied with a
suitable washer nozzle and mounting bracket. These should be fitted during installation with
the supplied fixing and positioned to allow cleaning fluid to reach the camera housing window
when the wash command is sent. The supplied washer nozzle brackets are specific to housing
type and are delivered pre-aligned for use.(Fig. 11 & 12)
When a wash command is sent to the camera, the unit will move to the factory set position to
allow for the screen to be washed.
For non-continuous rotation P&Ts and fixed housings the washer nozzle is installed on the front
window flange. (Fig. 13)
Fig.11
260mm Housing washer nozzle
Fig.12
400mm Housing washer nozzle
Fig.13
Non-continuous Rotation P&Ts and Fixed housings washer nozzle
© 2018, EATON
Installation Instructions
IM-SF-SC-SP-ST Issue 4
Page 13 of 40