Charging Up The Battery; Use - MAXXMEE 03605 Gebrauchsanleitung

Cordless Handheld Vacuum Cleaner
It can also be used with the brush and
crevice nozzle.
 
The crevice nozzle and the adapt-
ers can be used to suck up small
quantities of liquid.
CHARGING UP THE
BATTERY
Please Note!
■
Make sure that the USB cable does
not present a trip hazard.
■
Do not charge up on a computer
because the computer might be dam-
aged by the high charging current.
■
Connect the USB mains adapter to a
plug socket that is properly installed.
It must be readily accessible so that
the connection to the mains can
quickly be isolated.
Charge up the battery fully before you
fi rst use the device, or if the device has
not been used for a long time, so that it
reaches full capacity.
Otherwise the battery needs to be
charged if the device cannot be switched
on.
1. Plug the barrel connector of the USB
cable (8) into the charging socket (4)
and connect the A connector to a suit-
able USB mains adapter.
2. Connect the mains adapter to a plug
socket.
The charge control lamp in the A con-
nector lights up red and the battery is
charging.
When the charge control lamp lights
up green, the battery is fully charged.
03605_Inlay_de-en-fr-nl_A5_V1.indb 13 03605_Inlay_de-en-fr-nl_A5_V1.indb 13

USE

Please Note!
■
Make sure that there are no large,
sharp objects on the surface which is
to be cleaned.
■
Note the MAX marking on the
collecting container. If during use
the marking is reached, empty the
collecting container. Empty and clean
the collecting container after each
use. The fi lters must also be regularly
cleaned in order to prevent overload-
ing of the motor.
■
Switch off the device after you fi nish
cleaning each surface to signifi cantly
increase the operating time on each
battery charge. Charge up the battery
after use.
1. Select a nozzle (see the "Accessories"
chapter) and plug it into the suction
opening (13). For a longer reach, plug
the extension tube (9) in between.
 
The long adapter (11) is plugged
into the suction opening. The
short adapter (6) acts as a nozzle
or as an intermediate piece for
placing the brush nozzle (7) or
crevice nozzle (10) on the exten-
sion hose.
2. To switch on the device, slide the
On / Off switch (1) to the I position.
The light (15) switches on and the
vacuuming process begins.
3. Guide the nozzle over the area to be
cleaned.
4. To switch off the device, slide the On /
Off switch to the 0 position.
5. To ensure optimum performance of
the device, empty and if necessary
clean the collecting container after
every use (see next chapter).
EN
13
07.04.2021 16:45:40 07.04.2021 16:45:40