Battery Instructions - Renkforce WSF01 Bedienungsanleitung

G Operating instructions
Portable WLAN Document Scanner A4
WSF01
Item no. 1277811
Intended use
The product serves as a document scanner. Documents should not exceed the maximum
size of 21.6 cm wide and 120 cm long.
The product can be used in different ways and on different devices (it scans directly to a
memory card, via WLAN and app from a smartphone/tablet; from your PC via USB using the
enclosed software).
The scanner is either powered via USB or by 6 AA batteries (not included).
Carefully read this entire instruction manual which contains important information about
operation and use. Observe all safety instructions!
Important! Also, see the enclosed manufacturer's documentation in English.
Package contents
• Scanner
• USB cable
• Carrying bag
• Software CD
• Operating instructions
Safety instructions
D amages due to failure to follow these operating instructions will void the war-
ranty/guarantee. We do not assume any liability for any resulting damage!
W e do not assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions. The warranty/
guarantee will be void in such cases!
Dear customer,
the following safety instructions and hazard warnings are intended not only to
protect your health but also to protect the device. Please read the following
points carefully:
• The product is only suitable for dry, enclosed indoor areas. Do not expose the
product to direct sunlight, heat, cold, humidity or moisture; otherwise it may be
damaged.
• The product is not a toy and it should be kept out of the reach of children. Posi-
tion the product so it is out of the reach of children.
• Protect the product from cold, heat, direct sunlight, dust and dirt.
• Handle the product with care; impacts, blows, or accidental falls, even from a
low height can damage the device.
• Do not leave packaging material carelessly lying around, since it could become
a dangerous plaything for children.
Battery instructions
• Batteries should be kept out of the reach of children.
• Do not leave batteries lying around in the open; there is a risk of them being swallowed by
children or pets. If they are swallowed, consult a doctor immediately.
• Leaking or damaged batteries can cause burns if they come into contact with the skin.
You should therefore wear suitable protective gloves.
• Please pay attention to the correct polarity (plus/+ and minus/-) when inserting the bat-
teries.
• Batteries must not be short-circuited, opened or thrown into a fire. There is a risk of
explosion!
• Do not recharge single-use, non-rechargeable batteries. There is a risk of explosion!
All manuals and user guides at all-guides.com
• Replace a dead battery as soon as possible with a new one, or remove the spent battery.
• Remove the batteries, if you do not use the device for a longer time (e.g., storage). As the
• Always change a set of batteries at once; use only the same type and brand of batteries
Power supply
The scanner can be supplied with power in 2 different ways. One way is via USB and the
other via 6 AA batteries. Depending where and how you intend to use the scanner, you can
choose between these two, or simply stick to one. If you are connecting the scanner to the
PC for instance, it is automatically powered via USB. If you intend to use it on the go, you
would need to rely on battery operation.
To insert the batteries, refer to the chapter Inserting/Replacing Batteries.
Use the included USB Y cable for USB connections. Use both connectors of the Y cable and
connect the cable to 2 separate USB ports.
Alternatively, you can use the USB cable in conjunction with a USB power adapter.
Direct scan to memory card
Here you can scan directly by using the function keys of the scanner. The power can be
supplied either by batteries or USB. The documents are stored on the memory card. You can
then easily read these when you connect the scanner via USB to a computer.
• First, you need to insert a memory card (micro SD or micro SDHC) into the card slot on the
• Then turn on the scanner. Hold down the middle key on the control panel for about 3 sec-
• The scanner is automatically set to scan to a memory card when you start the scanner.
• Now the main menu is shown.
• By using the right button of the control panel you enter the menu settings.
• In the menu you can select the following settings in that order: Mode (memory card or
• In any case, you can now set the date and time and configure your other settings.
• With the help of the slider adjust the size of the page you want to scan, before scanning it.
• In order to now scan the page, simply push it from the front into the slot. The page is au-
• To transfer the images to your PC or MAC, copy them simply by either using a card reader
A dead battery may leak and can damage the device!
battery ages, it poses a danger of leaking, which then can cause damage to the product.
The warranty will be void!
with the same state of charge (do not mix fully charged batteries with half-empty or empty
ones).
The settings you make here (DPI, time, etc.) will only be stored as long as the
scanner is powered on. That is, only as long as the batteries are inserted or a USB
cable is connected.
back.
Slide the card in until it snaps into place. The metal contacts must point upwards.
onds until the display shows something.
The display will show a memory card for a few seconds. You can confirm the selection
immediately by pressing the middle key.
By pressing the arrow key up (DPI), you can toggle between the DPI settings (300/
600/1200 DPI).
By pressing the arrow key down (JPG/PDF), you can toggle between images and PDF.
The left button lets you switch into image view. Here the last scanned document will be
displayed. The arrow keys allow you to scroll through the scans. With the right key you
can delete unnecessary documents instantly.
You can move up or down in the menu using the two arrow keys. Once you have selected
your desired setting, press the key in the centre. The red selection rectangle moves to the
right and you can change the desired setting. Confirm your input with the middle key. Go
back by pressing the left key.
WLAN; colour or greyscale; resolution (300/600/1200 DPI); file format (JPG or PDF); en-
cryption; formatting of the memory card; setting the date and time
tomatically pulled through and scanned. After the scan is finished, the document appears
briefly on the display.
or connect the scanner with the USB cable directly to your PC or MAC.
After turning it on, select the function USB (USB connector on the monitor). Your PC dis-
plays now a new removable disk with the documents.