Mount Into The Dashboard - Philips CE235BT/13 Bedienungsanleitung

ISO male
connectors
i Yellow strip
2
&RQQHFW WKH DQWHQQD DQG DPSOLÀHU DV
illustrated, if applicable.
e
f
L
REAR
R
d c b
Sockets on rear External sockets or
panel connectors
1 For ISO male As indicated above
connectors
2 REAR L Rear left speaker
3 REAR R Rear right speaker
4 ANTENNA Antenna
5 Purple strip OE remote control
module
6 Black strip Ground
Tip
‡
The pin arrangement for the ISO connectors depends
on the type of your vehicle. To avoid damage to the
unit, connect properly.
8 EN
Connect to
To the +12V car
battery which is
energized at all
times
a

Mount into the dashboard

‡ If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
‡ If the car battery is not disconnected, to
avoid short-circuit, make sure that the bare
wires do not touch each other.
1
Make sure that the car dashboard opening
is within these measurements:
2
Remove the mounting sleeve with the
supplied disassembly tools.
3
Install the sleeve into the dashboard and
EHQG WKH WDEV RXWZDUG WR À[ WKH VOHHYH