Body Analysis; Programming / Enter Of Personal Data; Weighing Function (Weight Measurement Only) - ADE Simone Bedienungsanleitung

There is a little push button UNIT at the bottom side of the scale for country specific
setting with the option to switch from kg = kilogram to lb = pound or to st = stone.
Please pay attention to use the scale under consideration of your country specific unit of
weight.

4. Programming / Enter of personal data

Before first time use your personal data like gender (female / male or female sports /
male sports), body height and age must be programmed and saved under selected
locations P0 – P9 (up to 10 persons). The enter keys are located below the display. To
enter your personal data please utilise the buttons: SET (on and save button),
button),  (minus button) and follow the particular points:
1. Press the SET-button. The display indicates flashing "P0". To select your personal
location (P0 – P9), press the - or ‚-button. After the selection of your personal
location, press the SET-button to save the reading.
2. After you've selected your personal location (e.g. P3), the symbol for gender starts to
flash. To select the requested gender (
female sports), press the - or ‚-button. After the selection of your gender, press
the SET-button to save the reading.
3. After you've selected your gender (e.g. female), the symbol for age starts to flash
(default 25 age). To enter your age, press the - or ‚-button. After the selection for
your age, press the SET-button to save the reading.
4. After you've selected your age, the symbol for body height starts to flash (default
165 cm). To enter your body height, press the - or ‚-button. After the selection of
your body height, press the SET-button to save the reading.
After input completion, the display indicates "0.0 kg" and a few seconds later, the scale
automatically powers off.
To enter personal data of further persons please repeat the steps listed below.

5. Weighing function (weight measurement only)

1. Switch on the scale by using the Tap-on-function. For this, tap with your foot short
and powerful on the scale. The display indicates all symbols and a few seconds later
"0.0 kg". Now the scale is ready to use.
2. Step on the scale. Remain stationary on the weighing platform and do not hold you
tight. After a few seconds, your weight will indicate.
3. Step off the scale after weighing. The scale will switch off automatically after a few
seconds.
‚
male, female, or male sports,
4

6. Body Analysis

An analysis is only possible in bare feet. Your personal data must be entered first (please
see page 4).
1. Switch on the scale by using the Tap-on-function. For this, tap with your foot short and
powerful on the scale. The display indicates all symbols and a few seconds later
"0.0 kg". Please select your personal memory location (where your personal data are
stored) by using the - or ‚-key. Your personal data will indicate and then the scale
returns to "0.0 kg".
(plus
2. Now, carefully step in bare feet on the stainless steel electrodes (measuring units) of the
scale and remain stationary.
3. At first, your weight will indicate on the display. Shortly after, while the analysis is taking
place, the signal "o" starts to move in the display. After completion of the measurement,
your measured values will be shown as follows:
Your weight in kg, your body fat in %, your body water in %, your muscle mass in %
and your bone mass in kg.
After a few seconds the scale switch-off automatically.
EXAMPLE:
Weight
44.7
Body Water
The body fat content is shown as the amount of stored fat as a percentage of total body
weight. There is no generally accepted set value as this varies significantly according to
gender (due to the different build) and age. Body fat is vital for basic body functions. It's
protecting organs, cushioning joints, regulating body temperature, storing vitamins and
serves the body as energy storage.
68.5
21.9
kg
7.9
% %
Muscle Mass Bone Mass
5
Body Fat
%
3.6
kg