SELFSAT SNIPE DOME 2 Bedienungsanleitung Seite 11

C. Additional settings
i. BT button
a. Press BT button to change to BT setting screen. Press the arrow to move to the desired function
and set with the SET button
BT SET
REMOVE MAC
PRESS SET
R
BT SET
REFIND ON
PRESS SET
BT SET
R/C Update
PRESS SET
b. Press and hold BT button for more than 5 seconds to reset the remote control
D. Error message
O- 39 : E4 D
ASTRA 1
Error 6F
The errors message are shown in the table below.
0x00
0x6A
0x6B
0x6C
0x6E
0x6F
0x70
0x71
Delete the MAC Address of antenna stored in the remote control.
Used to connect to other products
Research function can be turned on / off.
The research function is a function that automatically moves the antenna
to the position of the last received satellite signal when the receiver is
turned on.
When the Research function is turned on, [R] mark in the first line
Used to update the remote control firmware.
Press the SET button to restart the remote control in update mode
If an error occurs during operation, the error number appears with the
error statement.
Not indicated
Home position
AZ Motor movement
EL Motor Movement
NID Check fail
Tuner lock fail
EL Up LIMIT Error
EL Down LIMIT Error
ENGLISH - 10